Pulsite-link流量信号处理器

Titan’s programmable Pulsite® Link allows the user to convert standard pulse output flow meters to give linearised analog and NPN/PNP outputs. The device will accept both pulse and reed switch devices and provides 5Vdc to the installed flow meter.Titan’s Interface Software allows the user to configure and test the system via USB and a computer. Calibration data can be entered in order to linearise the flowmeter signal for greater accuracy. There is easy access to the USB connection to allow adjustment of settings without the need to uninstall the unit. The USB connection via the base port offers datalogging of paramenters via PC and Titan’s Interface Software. ASCII flow information can be directly received from the USB connection to ease installation for computer information systems if required.The Pulsite® Link offers NPN, PNP pulses and analog output of 0-5Vdc / 0-10Vdc or 4-20mA and the ability to configure flow alarm outputs.• Outputs: 4-20mA (active), 0-5Vdc or 0-10Vdc, NPN and PNP logic direct outputs• Output test signals via software• Inputs: Pulse or Reed switch inputs• Inbuilt sensor power supply (+5Vdc)• Analog response rate from 100ms• Inbuilt Linearisation• User programmable settings; easy access USB• Up to 10 Calibration point input values• ASCII data streaming of flow measurement• Datalogging via PC• Software indication for system set up• Configurable flow alarm outputs• LED indicators• 0-65°C• IP64 Enclosure• Wall or panel mounting